Microgrids

Cat Power Grid Stabilization (PGS) Module

Cat®Power Grid Stabilization-moduler (PGS) er skalerbare stabiliserings-moduler, der hurtigt kan implementeres i GRID-systemer. PGS-modulerne har en effekt på er 840-1.260 kW og er indbygget i en 20 fods container. Elektronikken i PGS-modulerne er med til at udjævne spændingen og frekvensen i et GRID-system og kan også bruges til at stabilisere strømmen ved opstart af gas-drevne generatorsæt. Når PGS-modulerne indsættes i GRID-systemer baseret på vedvarende energi, har de tilstrækkelig kapacitet til at levere backup-strøm i op til 30 minutter, når den vedvarende energikilde ikke er tilgængelig (fx når solen ikke skinner). Modulerne kan opsættes og forbindes parallelt med andre PGS-modulers såvel som med ETS- og ECE-moduler. PGS-moduler kan overvåges og styres med Caterpillars Microgrid Master Controllers. Til mobile opgaver anbefales Power Grid Stabilization (PGS) 20' Heavy Duty mobil-modulet, der er monteret på en sættevogn.

Stabilisering Op til 1,2 x overload kapacitet

Kapacitet (kW) 840-1.260

Anvendelse Energi-stabilisering/-lagring

Up To 1.2x Overload Capability

Up To 1/2 hr Continuous Power

Protects against power failure, voltage sags/surges and under/over frequency

Over 100+MW Parallel-ready

Multiple modules used in parallel increase total output

Specifikationer

Technical Summary

Application	Transient Assist
Module Type	Grid stabilization
Rated Power	840-1260 kW

Power Grid Stabilization (PGS) module

Download (PDF)

Fordele og funktioner

Reliable and scalable

Factory prepackaged and tested

Pre-engineered containershipped as a single unit with batteries, inverter, isolation transformer and other equipment installed.
Parallel ready - multiple modules may be used in parallel to increase total output up to 100+MW.

Renewable integration

Designed to work with an array of renewable systems, including solar and wind
Seamless integration with Cat Microgrid Master Controller (MMC) allows for maximum renewable penetration and full asset control

Transient assist

When used with a generator set, the Cat PGS module will provide reserve power capacity to:

Decrease the transient voltage and frequency dips resulting from the application of large loads.
Enables highly-efficient lean-burn gas gensets to operate in island mode.

Grid stabilization

Protects against many typical power problems, including power failure, voltage sags/surges, and under/over frequency conditions.

High performance inverter

Built-in controls for the charging and discharging of the energy storage equipment.
Static VAR compensator.
Four-quadrant output power factor control.
Automatic anti-islanding to meet UL 1741 and synchronization back to grid.

Applicable standards and certifications

UL Listed to the following standards (certification and mark pending):

UL 9540
UL 1741 SB
CSA C22.2 No. 107.1/16
cULus mark

Declarations (pending):

CE Declaration of conformity
IEC60204-1

Cat Power Grid Stabilization (PGS) Module

Specifikationer

Power Grid Stabilization (PGS) module

Fordele og funktioner

Cat Power Grid Stabilization (PGS) Module

Få et tilbud

Cat Power Grid Stabilization (PGS) Module Microgrids